[Solved] Top layer bulging outwards?  

  RSS
BulldogNine
(@bulldognine)
New Member

I am getting this bulge at the top layers (and slightly at the bottom layers above the first layer) when I begin printing PETG now. I believe this is occurring in the area where there is solid infill. I have adjusted my Live Z to what I believe is the correct distance and I lowered the Extrusion Multiplier to 0.95 which only moderately helped. Any thoughts on how to reduce or eliminate this issue?

 

Posted : 16/05/2021 1:19 am
--
 --
(@)
Illustrious Member

This is typical of a loose belt drive gear slipping on the motor shaft. 

Posted : 16/05/2021 10:56 am
Share:

Please Login or Register