Notifications
Clear all
problems printing the infinity cube
Hi
Im having some truble printing the infinity cube from: https://www.prusaprinters.org/prints/928-yet-another-fidget-infinity-cube-v2
as you can see the hinges have their top layer torn off, when i break it free, after its done printing. I tried the following:
- -more expensive pla
- -cheap pla
- -tried to raise the z level a bit, so the layers does not get pushed that hard together
- - lowering print temp. printing at 215 and tried 200.
i even tried down just downloading the gcode from the site, to rule out any slicer problems, same problem still.. the funny thing is there is no problem printing it on my ender 3v2.. The printer has done the first setup thing without any problems.. So what am i missing?
Posted : 20/10/2021 5:45 pm
Show the bottom layer
"even raised the Z a little bit so the layers don't get ..." - um.. No. No..
Posted : 21/10/2021 6:39 am
Topic starter
answered:
thats helpfull
"even raised the Z a little bit so the layers don't get ..." - um.. No. No..
well it was just a test...
Posted : 21/10/2021 12:26 pm