Notifications
Clear all

Printed X Carriage, Can't Fit Timing Belt  

  RSS
bkim808
(@bkim808)
New Member
Printed X Carriage, Can't Fit Timing Belt

Hi guys!

I have been trying to print the x-carriage for my MK3S+ upgrade and for some reason, I keep ending up with the right side being really tight. I have shredded the end of my timing belt trying to cram it in there. I am printing with Prusament PETG Black @50mm/s, 240/90deg. I haven't had an issue with tolerances on any of my other parts, so I'm wondering if I should be slowing this print down or if there are any adjustments I should make?

Posted : 21/01/2021 8:48 pm
Share: