Print Issues - Bed Sticking?
Anyone have suggestions for my this is happening to my print? I have tried adjusting bed and extruder temperatures, have cleaned the bed and applied glue. Calibration and bed leveling seems fine. But this consistently happens. Using PLA. Bed temps I tried were 60 and 70, no real change, and extruder I changed from 215 - 190, and still not much change. I have had prints that came out well, but it is very inconsistent. Seems like a bed sticking issue. Any suggestions would be helpful.
RE: Print Issues - Bed Sticking?
I give my build plates a really goof wash with dish soap, rinse with hot water, dry immediately, and print PLA at 65 to 70 bed temperature. 
I also use 7x7 mesh bed levelling, and 'Life Adjust Z, My Way' to set the Live Z height.
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK