Notifications
Clear all

Poor quality above support  

  RSS
srbell
(@srbell)
New Member
Poor quality above support

I never noticed this before my latest firmware update, but everything above the support material looks extremely under extruded.  There are gaps between all the perimeter and solid infill layers.  I kept the Z contact spacing to .1 and increased the interface layers from 2 to 4, but got the same results.  I'm printing pteg and the rest of the print looks great.

Posted : 01/08/2021 12:01 am
fuchsr
(@fuchsr)
Noble Member

Are you talking about just the first layer above the support, or everything else above it? Pictures might be helpful. 

Posted : 01/08/2021 7:51 am
ssill2
(@ssill2)
Noble Member
I'm going to go out on a limb

but it sounds like this is the same issue as

https://forum.prusaprinters.org/forum/original-prusa-i3-mk3s-mk3-how-do-i-print-this-printing-help/supported-layers-are-stringy/

 

Posted : 02/08/2021 10:24 pm
Share: