Notifications
Clear all

Pla problem with cylindrical objects  

  RSS
Amutep
(@amutep)
Active Member
Pla problem with cylindrical objects

Hello

Im very happy with my mk3 but there is one problem i cant fix. Te problem come up only in round/cylindrical objects.

i printed the benchy all ok only chimney has "staggered layers" ?

so i printed some spare parts same issue maybe someone has an idea ?




thx

Posted : 22/06/2018 3:14 pm
thrawn86
(@thrawn86)
Honorable Member
Re: Pla problem with cylindrical objects

can't see the pics

Posted : 22/06/2018 8:13 pm
Amutep
(@amutep)
Active Member
Topic starter answered:
Re: Pla problem with cylindrical objects




Posted : 23/06/2018 1:15 am
thrawn86
(@thrawn86)
Honorable Member
Re: Pla problem with cylindrical objects


pics

much better. so the issue is the unsightly seam?

Posted : 24/06/2018 4:12 am
Amutep
(@amutep)
Active Member
Topic starter answered:
Re: Pla problem with cylindrical objects

hello

no tht seam is ok i think the seam comes from that i am printed without vase mode.

my problem is that there are no perfect circles not easy to make a photo

on this pic you can see my problem

Posted : 24/06/2018 12:51 pm
Gato
 Gato
(@gato)
Reputable Member
Re: Pla problem with cylindrical objects

Small surface area so might not have enough time to cool down before laying the new layer on top. Have you tried slowing down speed in that area or maybe lowering temp a tiny bit? I would also double check that you are not overextruding. There is a setting in Slic3r to slow down if time is under X seconds.

Posted : 25/06/2018 1:02 am
Amutep
(@amutep)
Active Member
Topic starter answered:
Re: Pla problem with cylindrical objects

hello

thx i test it with slower speed printing. that make sense because it is a small circle

Posted : 27/06/2018 9:23 am
Share: