Is there a way to print individual parts from the lack enclosure?
 
Notifications
Clear all

Is there a way to print individual parts from the lack enclosure?  

  RSS
Ezmack
(@ezmack)
New Member
Is there a way to print individual parts from the lack enclosure?

Got my printer a few days ago, making an enclosure to keep the cat out is my top priority. I put it in the closet temporarily but my neighbor didn't appreciate having it run 24/7. So since its no longer in the closet I dont want to be running 16-20 hour prints. Is there a way I can break these files into smaller parts instead of running a full plate of parts?

Best Answer by hli:

You can load the 3MF files into PrusaSlicer, and then remove the parts you don't want for that particular print. Note that these files also contain print settings, so have a look at the selected profiles.

Posted : 27/01/2021 5:41 pm
hli
 hli
(@hli)
Trusted Member
RE: Is there a way to print individual parts from the lack enclosure?

You can load the 3MF files into PrusaSlicer, and then remove the parts you don't want for that particular print. Note that these files also contain print settings, so have a look at the selected profiles.

Posted : 28/01/2021 11:42 am
fuchsr
(@fuchsr)
Noble Member
RE: Is there a way to print individual parts from the lack enclosure?

Sure. I ran into a few issues on one or two of the files and used PrusaSlicer to break them into each component separately. 

 
Posted : 28/01/2021 1:20 pm
Ezmack liked
Ezmack
(@ezmack)
New Member
Topic starter answered:
RE: Is there a way to print individual parts from the lack enclosure?

@hli

Thanks ! I actually figured it out by the time mods let my post through. I know solid works to an extent still finding all the buttons and options on prusaslicer

Posted : 28/01/2021 3:03 pm
Share: