Notifications
Clear all

Inconsistant texture on frist layer  

  RSS
spin02
(@spin02)
New Member
Inconsistant texture on frist layer

I've been getting some inconsistencies on the first layer of a larger diagonal print.  Here are a couple of pics of a tap handle I printed. It's usually in the middle of the bed but looks better closer to the sides.

This is hatchbox PETG, with the prusament profile. Prusament behaves the same way. Any thoughts?

Posted : 28/07/2021 5:23 pm
Diem
 Diem
(@diem)
Noble Member

Revisit your first layer Z calibration.

You are a fraction too low; very carefully reduce the negativity, you are very close so baby steps are in order. 

Cheerio,

Posted : 28/07/2021 6:34 pm
Share: