Notifications
Clear all

First layer issues  

  RSS
Kurwa30
(@kurwa30)
New Member
First layer issues
  • What can I do to improve my first layer print ? Should I just go further down with my z adjustment ? Is that normal that I’m higher in the center of my print bed than the rest of the Print bed ?

thank you for your help ! 

Posted : 23/02/2021 2:09 am
Dan Rogers
(@dan-rogers)
Noble Member
RE: First layer issues

Live Z.  Go closer.  Be aggressive.  Until the strands are sticking together, go lower.  If the strands start stringing you went too low.

 

Posted : 23/02/2021 3:42 pm
Share: