Notifications
Clear all
Falcon Heavy Landing Legs
I've been having trouble getting this part to print, I'm using Prusa Silver PLA with Prusa-Slicer settings.
One I stopped early when I noticed how bad it started to get, the other I let finish and I trimmed it up a bit.
Currently these are the only parts I'm having trouble with everything else is looking great.
Posted : 24/11/2019 1:26 pm
RE: Falcon Heavy Landing Legs
Is the part lifting off the bed?
ps: warping of large long parts is common. Even with PLA. A clean bed and higher bed temps help.
This post was modified 4 years ago by --
Posted : 25/11/2019 11:35 pm
Topic starter
answered:
RE: Falcon Heavy Landing Legs
@tim-m30
No lifting,
Using PLA, Temp 200, Infill 80%, 0.10mm Detail.
Posted : 26/11/2019 1:20 pm
RE: Falcon Heavy Landing Legs
Looks like over-extrusion then ... not sure why you are using 80% infill, either. The part shouldn't need it.
Posted : 27/11/2019 2:14 am