Can´t resume the print after power outage  

  RSS
Richard_H
(@richard_h)
Active Member

Hi,

after two and a half hours of printing, I stopped it because I wanted to lube the axis. Somehow, maybe the power cable was badly connected I had a very brief power outage, but after the screen turned back on, the print resume option didn´t show up.  Is there any way I could resume it? 

Thank you for your help.

Posted : 19/01/2021 3:54 pm
Swiss_Cheese
(@swiss_cheese)
Reputable Member

you mentioned you stopped the print, did you click the stop print option in the menu?

Posted : 20/01/2021 4:11 am
Richard_H
(@richard_h)
Active Member

@swiss_cheese

Yes, I did. BTW I may have used the wrong word, I didn't stop it I just paused it. 

 

Posted : 20/01/2021 7:42 am
cwbullet
(@cwbullet)
Illustrious Member

@richard_h

I don’t think you can restart that print.  

--------------------
Chuck H
3D Printer Review Blog...
Posted : 20/01/2021 10:42 am
Swiss_Cheese
(@swiss_cheese)
Reputable Member

@richard_h

If you stopped the print, that's it you cant resume. if you paused the print you should be able to resume within a reasonable amount of time. If power panic kicks in, you should be given the option to resume once the power is restored. I've never had an occasion when I had a print paused and the power went out, but it sounds like it's not going to resume from that point, and you would need to start the print over.

Posted : 20/01/2021 3:34 pm
Share:

Please Login or Register