Notifications
Clear all

Can someone slice this propertly?  

  RSS
timvdhoorn
(@timvdhoorn)
Active Member
Can someone slice this propertly?

Could someone send an example slicing of this thingiverse model?

https://www.thingiverse.com/thing:3529419

https://www.thingiverse.com/thing:3529419
https://www.thingiverse.com/thing:3529419

www.thingiverse.com/thing:3529419 

I really like it but I cannot seem to slice it without leaving blobs in the print. I did it on 0,15mm

Thanks!

Posted : 17/07/2021 10:07 am
JoanTabb liked
JoanTabb
(@joantabb)
Moderator
fluff

Hi Tim, 
there has been a problem with the link from thingiverse,  I have reported it to the developers. 
regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK...
Posted : 17/07/2021 11:18 am
Diem
 Diem
(@diem)
Noble Member

The default Prusa settings seem OK, no need for support or any special settings.

BUT

I suggest you think again; thermoplastic candle holders are not a good idea and this object might be a significant fire risk.

Cheerio,

Posted : 17/07/2021 3:42 pm
ssill2
(@ssill2)
Noble Member
wrong material

I would agree that if you're actually intending this to be a functional candle holder it would present a fire hazard.  But I would probably say that tea-light candles would be less risky than something where the candle wax is in actual contact with the model.  But caution is still warranted.  Yesterday I printed a candle stick holder in PLA just as a halloween decoration though I don't intend to actually put a candle in it.  it's just a prop.

Posted : 18/07/2021 4:09 pm
Swiss_Cheese
(@swiss_cheese)
Noble Member
Flame On! 💣

I think it would be fine for the LED candles they are selling these days, although if you were to print this in ABS or some other plastic with high resistance to ambient heat I think it would be fine as a real candle holder.

 

Avoid PETG and PLA for this if your planing to put real flame producing candles in it. personally I would just go with the LED candles.

 

Be Safe

 

Swiss_Cheese

The Filament Whisperer...
Posted : 18/07/2021 6:00 pm
Share: