Can I vary the infill at more than one "band" in Prusa Slicer?
 

Can I vary the infill at more than one "band" in Prusa Slicer?  

  RSS
Andrew
(@andrewld)
Estimable Member

Hi folks

In researching variable infill %'s I found that I can vary it between set layer heights. I just cannot see where/how I can do this multiple times in the same model. I have a medium sized model that will take 6h8m at 15% and only 3hr20m if the middle chunk is at 5%. But There are some bits that really could use some additional infill but they are part way up. I reckon 5% is too brutal but if I could switch between %'s at heights of my choosing I could have the best of both worlds. So my questions are;

a) - Can I?

b) - How?

Thanks in advance

Andrew

Best Answer by Neophyl:

See the knowledge base at https://help.prusa3d.com/en/article/modifiers_1767. You can either set multiple height range modifiers or you can use a normal parts modifier and set the infill that way in a specific area. 

Posted : 06/06/2020 3:16 pm
Neophyl
(@neophyl)
Noble Member

See the knowledge base at https://help.prusa3d.com/en/article/modifiers_1767. You can either set multiple height range modifiers or you can use a normal parts modifier and set the infill that way in a specific area. 

Posted : 06/06/2020 5:18 pm
Andrew
(@andrewld)
Estimable Member

@neophyl

Brilliant. Thanks. I will have a look at that.

Andrew

Posted : 06/06/2020 5:27 pm
Share:

Please Login or Register