Notifications
Clear all

Advice on printing Prusa PETG  

  RSS
Benoit
(@benoit)
Active Member
Advice on printing Prusa PETG

Hello,

I recently bought some prusa PETG filament and made some print successfully. 

I'm now trying to get the best settings for the filament. The result i got is ok but i'd like to know if i can get better.

Here's my settings/print environnement :

  • Filament has been dried 8 hour in the oven at 70° (this took care of some blobs)
  • i'm using the stock Prusament PETG profile
  • printer has undergone maintenance recently (belt tension is ok, etc)
  • prusament petg urban grey
  • Layer height is 0.10 mm

Here's a benchy with all these settings. I think there is a little under extrusion. Bridges are not so great but i get this is a limitation of the petg. Also there's a line at the deck level i can't remove.

What do you guys think ?

 

Thanks,

This topic was modified 4 years ago by Benoit
Posted : 27/05/2020 9:00 am
Share: