A consistent defect at 10cm height (and 16cm height) at all prints
 
Notifications
Clear all

A consistent defect at 10cm height (and 16cm height) at all prints  

Page 2 / 2
  RSS
christian
(@christian-4)
Eminent Member
Topic starter answered:
The belt tension

I printed the tension-meter as suggested by @diem, and both belts are bellow minimum. I guess I have to tighten the belts and test again 🙂

Posted : 30/09/2021 7:17 pm
christian
(@christian-4)
Eminent Member
Topic starter answered:
Problem solved

I tensioned the belts

Reprinted the cylinder, it was perfect

Reprinted one of the parts, it was perfect

Problem solved, thanks again!

Posted : 01/10/2021 10:10 pm
Swiss_Cheese
(@swiss_cheese)
Noble Member

@christian-4

 

Thank goodness, or Diem in this case.

 

that was one of the easiest things it could have been.

 

Enjoy

 

Swiss_Cheese

The Filament Whisperer

Posted : 01/10/2021 10:41 pm
Diem
 Diem
(@diem)
Illustrious Member

Problem solved,

Not so fast: problem mitigated.

The loose belts were permitting some other problem to manifest in the print, you have not fixed that issue, you've masked it.

I suggest it's time for a general maintenance tune up.

See: https://help.prusa3d.com/en/article/i3-printers-regular-maintenance_2072

Cheerio.

Posted : 01/10/2021 11:21 pm
christian
(@christian-4)
Eminent Member
Topic starter answered:
Problem mitigated

thanks @Diem, a suggestion could be that the printer had an option for showing a maintenance warning after evert x hours, just an idea.

Posted : 02/10/2021 5:42 am
Diem
 Diem
(@diem)
Illustrious Member

This is just a user forum, for suggestions to reach Prusa devs go to Prusa's github.

Cheerio,

Posted : 02/10/2021 9:33 am
Page 2 / 2
Share: