Notifications
Clear all

XYZ Calibration failure  

  RSS
Sean
 Sean
(@sean-7)
Trusted Member
XYZ Calibration failure

My part shifted on the build plate and I got a blob of doom on my hot end. While I was trying to melt the blob off my thermistor tore so I took the entire extruder apart and replaced the thermistor.

So now I have everything back together again but when I run the xyz calibration the z axis moves to the top of the frame and then it asks me if I have the steel sheet on and when I say no it immediately reports back axes failure.

when I click the dial control to return to the main screen the status at the bottom of that screen says end stops hit.

I have manually moved the axis its moving nice and easy.

I have a few hundred hours on this printer and up to know I have had no issues but I am stumped and I don't know what the issue is now. The extruder is assembled correctly.

Does anyone have any suggestions?

Firmware is 3.3.1-845

Posted : 20/08/2018 3:14 am
Sean
 Sean
(@sean-7)
Trusted Member
Topic starter answered:
Re: XYZ Calibration failure

Solved my own issue. Broken black wire on the pinda probe. little solder n some shrink tube and we are back up n running.

Ordered some spare parts from Prusa for future.

Posted : 20/08/2018 9:16 pm
Share: