Notifications
Clear all

X axis “crack”Noise  

  RSS
destronicola
(@destronicola)
Active Member
X axis “crack”Noise
  • IMG_0172
  • hi. I have x axis with a crack noise when moving. I checked the bearings and packed them
  • with grease. The noise was reduced for about 1 hour printing work. After that the noise come again. What could I do. Maybe new bearings ? The printer is quite new with 26 working hours. Thanks. 
Posted : 02/06/2021 12:41 pm
Dan Rogers
(@dan-rogers)
Noble Member
RE: X axis “crack”Noise

Remember - always say no to Crack.

Posted : 03/06/2021 3:26 am
hawai
(@hawai)
Estimable Member
RE: X axis “crack”Noise

you're sure that's not the extruder clicking?

Posted : 03/06/2021 3:40 am
destronicola
(@destronicola)
Active Member
Topic starter answered:
RISPONDI: X axis “crack”Noise

@hawai

Hi. Yes I am quite sure. How could I make a test ?

Posted : 03/06/2021 5:04 am
saisuman
(@saisuman)
New Member
RE: X axis “crack”Noise

I heard a cracking noise, too. Turned out to be the filament rubbing vertically against the spool. If the filament between the spool and the extruder is somewhat taut, then X-axis movements will rub the filament across the pool, making that cracking noise. Untangling the spool so that the filament can roll out freely helped in my case. Not sure if you have the same problem.

Posted : 03/06/2021 7:26 am
destronicola
(@destronicola)
Active Member
Topic starter answered:
RISPONDI: X axis “crack”Noise

@saisuman

I dont think.. but thanks 

Posted : 03/06/2021 5:11 pm
Share: