Why does my print begin in the middle of the object and not complete to the edges? (Prusaslicer)
Why do my prints not begin in the corners and jump around the layer? Is there a setting I am missing? This ends up being noticeable when the print finishes. (It does this on the top and bottom layers too)
RE: Why does my print begin in the middle of the object and not complete to the edges? (Prusaslicer)
Try using monotonic infill for top infill.
RE: Why does my print begin in the middle of the object and not complete to the edges? (Prusaslicer)
Edit: Monotonic infill will address the inconsistent top layer. It is an option in the new PrusaSlicer 2.3 release, currently at RC1. You can download it from the PrusaSlicer GitHub page. If you don't want to use the pre-release version, try slowing down top layer infill and tweaking the top layer extrusion widths. Monotonic infill is the real fix though.
RE: Why does my print begin in the middle of the object and not complete to the edges? (Prusaslicer)
I'm sure it was a typo, but RC2 is current
The Filament Whisperer
RE: Why does my print begin in the middle of the object and not complete to the edges? (Prusaslicer)
I'm sure it was a typo, but RC2 is current
Good catch! Usually, after I post about a pre-release the final is released. I've been using RC2 and am not encountering any issues.
Edit: Just checked and RC3 is out.
RE: Why does my print begin in the middle of the object and not complete to the edges? (Prusaslicer)
@bobstro
I'm glad you posted that I hadn't checked in awhile.
The Filament Whisperer