Notifications
Clear all

Which Retract Value is taken?  

  RSS
Nomad965
(@nomad965)
Trusted Member
Which Retract Value is taken?

Need some clarification, I noticed that the Slicer has two areas where one can input the retraction settings one is under printer settings / extruder and the other is in Filament settings / filament overides.

The way I understand this is the default is under printer settings / extruder and the filament overides is the ones based on filaments defined by the user which will overide the ones set in printer settings, is this correct ?

Thank you

This topic was modified 4 years ago by Nomad965

Prusa i3 MK2s MK2.5s Mk3 Mk3s BearPrusa Zaribo 320 - Kit Build - Rc Driver - Tweak freak...
“I know nothing about surpassing others. I only know how to outdo myself.” -Bushido-

Posted : 27/05/2020 3:03 pm
Neophyl
(@neophyl)
Illustrious Member
RE: Which Retract Value is taken?

That is correct. The filament ones if set over ride the defaults. 

Posted : 27/05/2020 5:51 pm
Nomad965 liked
Nomad965
(@nomad965)
Trusted Member
Topic starter answered:
RE: Which Retract Value is taken?

@neophyl

Thank you for the clarification.

Prusa i3 MK2s MK2.5s Mk3 Mk3s BearPrusa Zaribo 320 - Kit Build - Rc Driver - Tweak freak...
“I know nothing about surpassing others. I only know how to outdo myself.” -Bushido-

Posted : 28/05/2020 3:09 am
Share: