Notifications
Clear all
Updated my MK3 to MK3s Software
OK after 2 years I decided to do a software updated on my MK3. When I was done I got a warning that the software I was using was for a MK3S. Is this a problem? If so, where do I find the latest MK3 software.
Posted : 11/09/2020 2:48 pm
RE: Updated my MK3 to MK3s Software
You can find them all on the Prusa github pages. Just read the firmware filenames carefully when downloading. If you installed the wrong version, just flash the correct version over it. You may want to do a factory reset and recalibrate your printer settings if you encounter any weirdness after upgrading.
Posted : 11/09/2020 2:53 pm
Topic starter
answered:
RE: Updated my MK3 to MK3s Software
Bobstro, thank you very much for your advise. I followed your instructions and all is well.
It is people like that take the time to help people like me that make this forum great.
Thanks again!
Posted : 11/09/2020 9:56 pm