Trouble printing circular brims Version 2.3.0 beta2 windows 10 64bit
 

Trouble printing circular brims Version 2.3.0 beta2 windows 10 64bit  

  RSS
Dan
 Dan
(@dan-21)
Active Member

Hi everyone. I'm printing with a swiss hot end direct drive on a ender 3 pro.  I having a problem printing a circular brims, the first 3 circles are as expected but the it starts printing over the last circle printed until it reaches the total circles set in brim settings. the inside of the circle is lifted because the nozzle is not moving inward. This doesn't happen on any other type of brim, just circular brims only.

I have the skirt turned off.

I have the brim turned on with a setting of 5.

Any suggestions or thoughts would be appreciated.

Danny

Posted : 10/12/2020 3:05 pm
towlerg
(@towlerg)
Noble Member

I'm using the same version of PrusaSlicer but on Win 7, although I can't see that being an issue. I just printed a round part with a 5mm brim no problem. Perhaps the part of the brim you printed, moved?

This post was modified 6 months ago by towlerg
Posted : 11/12/2020 1:02 pm
Share:

Please Login or Register