The Nozzle Preheat: ERROR
Of late I'm getting this blunder, and afterward I can't leave the mistake message to proceed to preheat the spout. This just happens some of the time. Ideas?
Now it's happening all the time. Printer is unusable.
RE: The Nozzle Preheat: ERROR
Of late I'm getting this blunder, and afterward I can't leave the mistake message to proceed to preheat the spout. This just happens some of the time. Ideas?
Now it's happening all the time. Printer is unusable.
Hello and welcome to Prusaforum!
The topic has already been discussed, e.g. here: https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-hardware-firmware-and-software-help/preheat-error-hotend-and-bed/
Tips from Prusa can also be found here: https://help.prusa3d.com/en/article/preheat-error_2163
wbr,
Karl
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.
RE: The Nozzle Preheat: ERROR
Sounds like a loose or broken thermistor or heater element cable.