Temperature and part fan speed not kept after filament runout
Hi,
I've been testing some samples and I ran into some filament runouts as expected.
The filament sensor worked great and paused the print and asked to change filament but after completing the change the prusa resumed the print correctly for a moment (2 seconds, more or less) and then nozzle temperature, bed temperature and part fan speed switched to 0.
I managed to save the print by quickly going to "tune" and setting all parameters correctly.
I'm running 3.2.0-RC2 and started the print from the panel from SD nothing else involved
Can anyone test that with RC2? and with the latest stable?
Thanks!
Re: Temperature and part fan speed not kept after filament runout
I had that happen to me yesterday, but I think https://github.com/prusa3d/Prusa-Firmware/commit/c359d118583f0b473a7ec77e673974ad3b032c51 should fix that. The message mentions the bed, but it disabled the timer for both nozzle and bed by the looks of it.
Re: Temperature and part fan speed not kept after filament runout
I mentioned that in another thread, I had to re-run the Wizard and the Problem was gone.
Re: Temperature and part fan speed not kept after filament runout
I mentioned that in another thread, I had to re-run the Wizard and the Problem was gone.
Hi Tobias,
I've read the RC2 thread (the last three pages at least) and I don't know what wizard you are talking about. I guess one of the calibrations... but which one?
Thanks!