Notifications
Clear all

Stop Print Behaviour  

  RSS
Qlmmy
(@qlmmy)
Active Member
Stop Print Behaviour

I have minor annoyance. After I manually do a "stop print", on starting the next one, it says "resuming...". I have it stop it again, then select the next print one more fo rit to continue as normal. This hasn't caused any problems, I'm just seeing if this is common.

I'm running MK3S 3.9.3 and MMU2S 1.0.6

I'd be willing to poke around in the firmware code if necessary. 

Posted : 10/03/2021 4:39 am
cwbullet
(@cwbullet)
Illustrious Member
RE: Stop Print Behaviour
Posted by: @qlmmy

I have minor annoyance. After I manually do a "stop print", on starting_ the next one, it says "resuming...". I have it stop it again, then select the next print one more fo rit to continue as normal. This hasn't caused any problems, I'm just seeing if this is common.

I'm running MK3S 3.9.3 and MMU2S 1.0.6

I'd be willing to poke around in the firmware code if necessary. 

Are you using octoprint?

--------------------
Chuck H
3D Printer Review Blog...
Posted : 10/03/2021 4:43 pm
Qlmmy
(@qlmmy)
Active Member
Topic starter answered:
RE: Stop Print Behaviour

@cwbullet

No. I'm loading it from the SD and manually stopping the print from the menu. 

Posted : 10/03/2021 5:01 pm
Share: