Notifications
Clear all
Stepper motor screw thread stripped
Hi everyone,
I've been printing out some ear protectors for the hospital I work in and in doing so, I believe I got some filament stuck in the ptfe tube. I've been following the prusa guide on how to replace the ptfe tube but in doing so I've stripped one of the screws on the back of the extruder stepper motor.
I've tried a rubber band and super glue but to no success. I'm a bit hesitant to use a dremel just due to the location.
Are there any other options to try and get this screw out?
Thanks!
Posted : 14/05/2020 10:56 pm