Selftest failure - X axis length
My MK3S upgrade threw me another curve. After performing a reset to get my hot end fan running again I was performing a calibration.
Using the wizard it fails on the selftest with a X axis length error. I was able to do XYZ calibration, but the selftest consistently fails on X length. The belt status shows X=250 Y=-1.
Thoughts?
Best Answer by x50arm:
Check your zip ties on the cables coming off your extruder to make sure they are turned properly and the latch portion is not contacting your frame. I have made this mistake several times.
RE: Selftest failure - X axis length
Check your zip ties on the cables coming off your extruder to make sure they are turned properly and the latch portion is not contacting your frame. I have made this mistake several times.
RE: Selftest failure - X axis length
Also, make sure the extruder doesn't have extras like a pretty fan grill, wrong screws holding the fan, etc. Fan cable must exit the top of the fan, not the rear, etc.
RE: Selftest failure - X axis length
Yup zip ties. I saw one was hitting the right side. After I adjusted it the X axis tested out just fine.