Notifications
Clear all

Selecting nozzle and bed-surface via printer-interface  

  RSS
ludodg
(@ludodg)
Estimable Member
Selecting nozzle and bed-surface via printer-interface

Hello,

I have recently switched to a 0.6-nozzle. So I chose the right profile in PrusaSlic3r ... exported to sd-card, sd-card into the printer ...
but then my printer gave a warning, telling me I had a wrong nozzle and it gave me a menu where I could choose the correct nozzle.

It is then that I also noticed that there was a setting for the bed: smooth or textured. It was fixed on smooth but I use the textured.
the printjob started and the menu disappeared.

How can I re-tune this as I intend to switch between nozzle's for the comming print-jobs?
I seem not able to find this in the MK3S-menu. 
Settings, calibration, ...

What am I overlooking?

Thx!

Posted : 17/04/2020 11:29 am
bobstro
(@bobstro)
Illustrious Member
RE: Selecting nozzle and bed-surface via printer-interface

Printer detection is a new feature in the printer firmware. You can set it to stop, pause or ignore mismatches. I find it an annoyance since I often switch nozzles and it doesn't really do anything (unlike the bed setting). I simply disable it. 

My notes and disclaimers on 3D printing

and miscellaneous other tech projects
He is intelligent, but not experienced. His pattern indicates two dimensional thinking. -- Spock in Star Trek: The Wrath of Khan

Posted : 17/04/2020 12:25 pm
ludodg liked
ludodg
(@ludodg)
Estimable Member
Topic starter answered:
RE: Selecting nozzle and bed-surface via printer-interface

OK, found it in the manual:

SETTINGS -> HW SETUP -> STEEL SHEETS
OR NOZZLE ...

Guess I'll have to wait untill the current printjob has finished to check this out 🙂

 

Posted : 17/04/2020 12:34 pm
ludodg
(@ludodg)
Estimable Member
Topic starter answered:
RE: Selecting nozzle and bed-surface via printer-interface

see manual (Engl.) p 41 :     8. advanced calibration

Posted : 17/04/2020 12:37 pm
Share: