Notifications
Clear all

[Solved] PrusaSlicer Import STL problem  

  RSS
Pedroid
(@pedroid)
Trusted Member
PrusaSlicer Import STL problem

Hi,

attached is a simple STL containing 2 orthogonal planes with thickness of 2 mm. One of the plane is rectangular, the other has a 45° angle.

When importing the file into PrusaSlicer the thickness of the plane with the angle decreases from the left button side to the right upper side from 2 mm to 0. I can find the same behavior in Slic3r purse edition but not in Cura. The STL file has been created by the STL Import & Export Add-on in Sketchup.

Eckanrisshilfe.stl

Best regards

Olaf

Best Answer by --:

Even Netfabb is not liking it; declares it non-manifold. Rectangles are all triangles, and have cross connected corners. Escher-like.

Repaired

Posted : 23/06/2019 10:15 am
--
 --
(@)
Illustrious Member
RE: PrusaSlicer Import STL problem

Slicer is reporting 6 errors ... Meshmixer found the weld isn't a weld.

This post was modified 5 years ago by --
Posted : 23/06/2019 3:35 pm
--
 --
(@)
Illustrious Member
RE: PrusaSlicer Import STL problem

Even Netfabb is not liking it; declares it non-manifold. Rectangles are all triangles, and have cross connected corners. Escher-like.

Repaired

This post was modified 5 years ago by --
Posted : 23/06/2019 3:43 pm
Pedroid liked
Pedroid
(@pedroid)
Trusted Member
Topic starter answered:
RE: PrusaSlicer Import STL problem

Thank you very much.

Posted : 23/06/2019 5:41 pm
Pedroid
(@pedroid)
Trusted Member
Topic starter answered:
RE: PrusaSlicer Import STL problem

Supplement for Sketchup users: The extension Solid Inspector2 in the extension warehouse seems to be promising. It can detect and fix various problems in solids before exporting the STL. 

Posted : 24/06/2019 6:01 pm
Share: