Hi,
I have a problem with my factory assembled mk3s. On most of my prints I get the problem with the clicking noise and no plastic getting through. This happens anywhere from an hour into a print or can be as long as 5 hours before it happens but it always happens.
Any help would be appreciated. I bought an assembled one because I do not like to tinker too much so I hope this can be solved quite easily.
Thanks in advance.
Joacim
Posted : 08/08/2019 9:28 pm
You have a partial jam. Research on Youtube how to do a cold pull. Then make sure your PTFE tube is all the way in.
Posted : 10/08/2019 12:55 am