Printer stops extruding and the infamous clicking sound can be heard
 

Printer stops extruding and the infamous clicking sound can be heard  

  RSS
joacim.l
(@joacim-l)
New Member

Hi,

I have a problem with my factory assembled mk3s. On most of my prints I get the problem with the clicking noise and no plastic getting through. This happens anywhere from an hour into a print or can be as long as 5 hours before it happens but it always happens.

Any help would be appreciated. I bought an assembled one because I do not like to tinker too much so I hope this can be solved quite easily.

Thanks in advance.

Joacim

Posted : 08/08/2019 9:28 pm
cwbullet
(@cwbullet)
Illustrious Member

You have a partial jam.  Research on Youtube how to do a cold pull.  Then make sure your PTFE tube is all the way in.  

--------------------
Chuck H
3D Printer Review Blog...
Posted : 10/08/2019 12:55 am
Share:

Please Login or Register