Not enough filament coming from the nozzle
After about 30 prints, my new i3-Mk3s is not printing. I have done all of the calibration tests, adjusted Live-Z and still not enough filament coming from the nozzle. A temperature check for PLA 215/60 showed 98/58. I removed the nozzle and it appears that the filament is backing up and not coming out of the nozzle. I am wondering if the temperature sensor on the nozzle is not working.
Any ideas....
RE: Not enough filament coming from the nozzle
Well, at 98C, the filament will most definitely not flow properly out of the nozzle.
I would suspect the heater element or the heater wiring before the thermistor.
RE: Not enough filament coming from the nozzle
After about 30 prints, my new i3-Mk3s is not printing. I have done all of the calibration tests, adjusted Live-Z and still not enough filament coming from the nozzle. A temperature check for PLA 215/60 showed 98/58. I removed the nozzle and it appears that the filament is backing up and not coming out of the nozzle. I am wondering if the temperature sensor on the nozzle is not working.
Any ideas....
98 degrees C. is way too low. I'd check the heating element and the thermistor. Maybe you got a loose connection or an element malfunctioning. I would always keep these parts on stock.
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.