New Raspberyy Pi Zero 2 W
There's a new Pi Zero with the same form factor. Immediately I thought of using it with one of my MK3S.
https://www.raspberrypi.com/products/raspberry-pi-zero-2-w/
You should ask Gina Häußge first to make sure it is compatible with Octoprint. Because the Zero 1 W was not.
It works
Just seen on Twitter that Gina confirms it works! It should work with the MK3S although she recommends a separate PSU.
I've ordered 2. I've a Mk3S+MMU2s that I may try it with.
Pins
I really wish they would release a RaspberryPi Zero 2 WH.
--------------------
Chuck H
3D Printer Review Blog
WH
At least this PL shop sells them: https://kamami.pl/raspberry-pi-zero-2/587963-raspberry-pi-zero-2-wh-z-512mb-ram-4x1ghz-wifi-bluetooth.html
I really wish they would release a RaspberryPi Zero 2 WH.
Power is going to trip up a lot of projects
Just seen on Twitter that Gina confirms it works! It should work with the MK3S although she recommends a separate PSU.
I expect we're going to see a lot of installs where it "works just fine" until you run into a power hungry RPi mid-print. Still, it was inevitable that an improved Zero was released. Glad to see it. Now to wait a couple of months to see if Microcenter offers them in-store for $5.
DVFS?
You could likely downclock CPU (lock on DVFS). This should do the trick.
Just seen on Twitter that Gina confirms it works! It should work with the MK3S although she recommends a separate PSU.
I expect we're going to see a lot of installs where it "works just fine" until you run into a power hungry RPi mid-print. Still, it was inevitable that an improved Zero was released. Glad to see it. Now to wait a couple of months to see if Microcenter offers them in-store for $5.
Pins
I agree. I am going to wait for a price drop and the pre-soldered pins.
Just seen on Twitter that Gina confirms it works! It should work with the MK3S although she recommends a separate PSU.
I expect we're going to see a lot of installs where it "works just fine" until you run into a power hungry RPi mid-print. Still, it was inevitable that an improved Zero was released. Glad to see it. Now to wait a couple of months to see if Microcenter offers them in-store for $5.
--------------------
Chuck H
3D Printer Review Blog