Notifications
Clear all
Re: Lines on outside when solid layer
Is that the sample gcode provided by Prusa or one you sliced yourself?
Posted : 19/08/2018 5:59 pm
Re: Lines on outside when solid layer
This is caused by wrong/bad/too much or less cooling. Try to optimize your colling settings.
Thomas
Posted : 20/08/2018 9:18 am
Topic starter
answered:
Re: Lines on outside when solid layer
Yes, this was the one preloaded on the SD card.
Posted : 23/08/2018 9:31 pm
Topic starter
answered:
Re: Lines on outside when solid layer
Thanks for the reply Thomas. I will work on my cooling.
Posted : 23/08/2018 9:31 pm
Re: Lines on outside when solid layer
I have the same problem.
What is the logic behind the cooling problem?
Regards
Magnus
Posted : 25/08/2018 12:18 pm
Re: Lines on outside when solid layer
Did anyone figure out if cooling was the problem here?
Posted : 01/03/2019 5:34 am