Just finished installation, lcd doesn’t turn on and it makes beep sound
 

Just finished installation, lcd doesn’t turn on and it makes beep sound  

  RSS
ali.s8
(@ali-s8)
New Member

I just finished assembling. However something is wrong and when I switch on the printer , it sometimes just makes a loud beep and lcd doesn’t turn on. What could be wrong. 
on a different note, I managed to break this heat fan wire from the clip. What’s the best way to fix it? 

sorry about the wiring mess.. trying to clean it up. 

Best Answer by Neophyl:

That doesnt look like a MK3.  Wrong PCB, wrong frame, wrong heatbed, wrong voltage.  You might want to post in the Mk2 or 2.5 forum (whichever printer you actually have) as responses there are likely to be more suitable.

Posted : 27/06/2020 1:07 pm
Neophyl
(@neophyl)
Noble Member

That doesnt look like a MK3.  Wrong PCB, wrong frame, wrong heatbed, wrong voltage.  You might want to post in the Mk2 or 2.5 forum (whichever printer you actually have) as responses there are likely to be more suitable.

Posted : 27/06/2020 3:37 pm
ali.s8
(@ali-s8)
New Member

That’s right. Sorry. I just noticed it’s MK2

Posted : 27/06/2020 4:56 pm
Share:

Please Login or Register