Intructions to replace hotend?  

  RSS
RustySocket
(@rustysocket)
Active Member

My hotend plugged up.  I broke the heater wires in the process of trying to clean it. I have ordered a entire new replacement hotend.  Is there some instructions on the best way to go about replacing this assembly or do I just start taking it apart in the reverse order as in the manual.  I thought somewhere I came across a prusa guide for this procedure but I cannot find it.

 

 

Posted : 18/04/2020 4:57 pm
bobstro
(@bobstro)
Illustrious Member

The Mk3 online assembly manual has good detail. I used it as a guide when replacing my hotend components. Just read each section and the notes carefully. Do make sure the version of the assembly manual you are viewing matches your printer.

My notes and disclaimers on 3D printing and miscellaneous other tech projects
He is intelligent, but not experienced. His pattern indicates two dimensional thinking. -- Spock in Star Trek: The Wrath of Khan...
Posted : 18/04/2020 5:43 pm
Share:

Please Login or Register