Install MMU2 on mk3s  

  RSS
jaychatt
(@jaychatt)
Eminent Member

Hello. I bought an MMU2 from someone local who had never installed it. I have an mk3s and I'm not sure where to start. Do I need to print parts to convert the MMU2 to an MMU2s? Do I need to buy new parts for the conversion? Would appreciate any advice! 

Posted : 06/03/2021 3:02 pm
Pecadis
(@pecadis)
Active Member

Hi there,

i would recommend you to take a look into the official assembly manual for the mmu2 and check which parts may be missing. Especially for the mk3s, you need to exchange some parts on the Extruder.

The manual: https://help.prusa3d.com/en/guide/1-introduction_36832

And The Partfiles so you can print the things missing: (on the right hand side unter upgrades) https://www.prusa3d.com/prusa-i3-printable-parts/

Posted : 07/03/2021 1:40 am
Share:

Please Login or Register