Notifications
Clear all

HOT Einsy board  

  RSS
CovertPluto3502
(@covertpluto3502-2)
Trusted Member
HOT Einsy board

I've been printing just fine for the last months, but I read temperatures of around 60*c on the board after printing for 20 hours. Is this normal? The board looks clean, and it has quite a lot of ventilation. Printer still prints like before but the board is quite hot.

Posted : 13/07/2020 5:10 pm
karl-herbert
(@karl-herbert)
Illustrious Member
RE: HOT Einsy board
Posted by: @covertpluto

I've been printing just fine for the last months, but I read temperatures of around 60*c on the board after printing for 20 hours. Is this normal? The board looks clean, and it has quite a lot of ventilation. Printer still prints like before but the board is quite hot.

You could stick heat sinks on the TMC2130 driver blocks and additionally equip the board with a 40x40mm Noktua fan. This will lower the temperature by about 10 degrees.

Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.

Posted : 13/07/2020 7:43 pm
Share: