Benachrichtigungen
Alles löschen

Get a tight bore from a stl file  

  RSS
jlc
 jlc
(@jlc-2)
Active Member
Get a tight bore from a stl file

Hello,
I print the original part "x-end-motor.stl" of the prusa MK2S but in output the bore (hole) to receive the bearings is too fair (not enough tight). I got the STL file from the Prusa3d website. Is it possible from a cutting software (Simplify3d or PrusaSlicer) to play on a parameter to obtain a smaller bore?
Thank you for your advice
Greetings
Jean-Luc

Veröffentlicht : 03/11/2019 10:21 am
Zoltan
(@zoltan)
Mitglied Moderator
RE: Get a tight bore from a stl file

In PrusSlicer you can only play with the scale,which is changing the whole model scale (in different axes) but not parts of it. For changing the hole size you have to use 3D design tool or create a cylinder with hole of desired diameter and merge your part with that cylinder  via PrusaSlicer.

even an old man can learn new things 🙂
Standard I3 mk3s, MMU2S, Prusa Enclosure, Fusion 360, PrusaSlicer, Windows 10
PRUSA MINI+ Prusalink + Prusa Connect

Veröffentlicht : 03/11/2019 11:06 am
--
 --
(@)
Illustrious Member
RE: Get a tight bore from a stl file

Suggest you print a 50 mm object and verify your printer is calibrated. If not, run the XYZ calibration again and then recheck.

Veröffentlicht : 03/11/2019 7:53 pm
Teilen: