Fix Through The Netfabb
Hey gang!
We are very new to the forum! Very excited to be here!
At our library, we have the same version of PrusaSlicer installed on 2 different computers; one is Windows 10 and the other is windows 7.
The PrusaSlicer that is on the Windows 7 computer is missing a feature ("Fix Through The Netfabb") that we would love to have!
Hopefully this image helps:
But the version of the software is the same!
Is this because of the Windows Version?
Any advice would be greatly appreciated.
We would love to have this "Fix Through The Netfabb" feature!
RE: Fix Through The Netfabb
Yes its because of Windows version. The fix through Netfabb is only available when on Win 10. However you can use a normal browser to go to the netfabb website and if you have an autodesk ? account you can log in and repair models through the browser. Its just not as convenient.
RE: Fix Through The Netfabb
@neophyl
oh no!
Thanks so much for the info!
I will make sure we get that computer switched over asap!
🙂
RE: Fix Through The Netfabb
Or just download and install NetFabb ...
RE: Fix Through The Netfabb
Thanks @tim-m30!
We do have and use Netfabb currently. This feature would just make things nice and simple!
🙂