First layer calibration loop  

  RSS
Kalimando Design
(@kalimandoend)
New Member

I recently had to take my top end apart to fix a small problem with a loose hotend, and upon rebuilding and calibrating the first layer calibrator gets stuck in a loop where it asks for filament to be inserted even when it has been in the same session. Should I reflash the latest update? Is there a hard reset?

Posted : 06/08/2020 12:01 am
joan.t
(@joantabb)
Veteran Member Moderator

could your filament sensor be on the edge of working, and giving false signals?

there is a sensor spacer for the mk3S filament sensor

on thingiverse

check your sensor status

regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK...
Posted : 06/08/2020 12:27 am
Kalimando Design
(@kalimandoend)
New Member

I think you might be right, when I was rebuilding it I just looked up the EINSY board photo on the knowledge base. The filament sensor is the only thing I had some confusion about since it has no "keying" to its male end. I might have put it in left handed instead of right handed.

Posted : 06/08/2020 9:25 pm
Share:

Please Login or Register