English
Forums
English forum
Original Prusa i3 MK3 & MK3S & MK3S+
Hardware, firmware and software help
Firmware and MacBook M1
 
Notifications
Clear all

Firmware and MacBook M1  

    Last Post
  RSS
Ratthy
 Ratthy
(@ratthy)
Eminent Member
Firmware and MacBook M1

I have change my MacBook for the new M1. I have purchased also an adapter to USB C to connect the printer into my Mac. 
I have also installed the latest version of the Prusa Slicer. 
I have try to flash my printer, but the software does not seem to see the printer. 

does everything is fully compatible with the new Mac hardware? Or it will better to use a USB hub? 

Posted : 03/02/2021 11:08 am
cwbullet
 cwbullet
(@cwbullet)
Member
RE: Firmware and MacBook M1
Posted by: @ratthy

I have change my MacBook for the new M1. I have purchased also an adapter to USB C to connect the printer into my Mac. 
I have also installed the latest version of the Prusa Slicer. 
I have try to flash my printer, but the software does not seem to see the printer. 

does everything is fully compatible with the new Mac hardware? Or it will better to use a USB hub? 

Others has reported this problem and no there is not work aroudn at this time.  

--------------------
Chuck H
3D Printer Review Blog

Posted : 03/02/2021 11:26 am
Ratthy
 Ratthy
(@ratthy)
Eminent Member
Topic starter answered:
RE: Firmware and MacBook M1

@cwbullet

Thank you. 

I have a workaround, bring my printer near my PC, or better, print my laptop from the job. 

Posted : 03/02/2021 11:52 am
  All forum topics
  Previous Topic
Next Topic  
Share: