I just did a Firmware upgrade to 3.9.1. Printer was was working fine except for Octoprint emergence stop error (Temp to Low). So I updated to 3.9.1. Now on my LCD I am seeing square blocks were the characters should be. See attached. Does. anyone have a suggestion what the issue could be?
This topic was modified 4 months ago 3 times by Nealz
Posted : 21/10/2020 11:41 pm
I went though the troubleshooting guide and it mentioned the squares would come up if I loaded the wrong firmware for my model. I selected
V3.9.1 MK3S (September 21, 2020)
I do not have the MMU. Isn't this prusa3d_fw_MK3S_3_9_1_3518.hex the correct one for a Prusa I3 MKS?
This post was modified 4 months ago by Nealz
Posted : 21/10/2020 11:56 pm
I reflashed the Prusa and now it is working.
😀
Moral of the Story... Read the Troubleshooting Guide!
Posted : 22/10/2020 12:07 am