Notifications
Clear all

Filament Profile will not add after Config Wizard  

  RSS
tim.o14
(@tim-o14)
Eminent Member
Filament Profile will not add after Config Wizard

Hello,

I tried to add a few filament profiles to the config wizard, but they will not show up as an option for the extruder; is there something that can be doen to make them show up?  The same 7 profiles are always available as a choice, but nothing new ever shows up.

Thank you!

Tim

Posted : 05/04/2020 4:27 am
Neophyl
(@neophyl)
Illustrious Member
RE: Filament Profile will not add after Config Wizard

Post an issue over on Github. 

Posted : 05/04/2020 12:51 pm
Share: