Extrusion fine for short period - then stops  

  RSS
tom.stephens.900
(@tom-stephens-900)
New Member

I'm having an issue with extrusion.

When I load filament, the bond gears rotate and properly feed the filament.  I get consistent, straight, continuous extrusion.  If I answer N to the Y/N prompt immediately after it appears, I continue to see consistent extrusion.  If however, I wait for several seconds before responding N to the prompt the result is that no further extrusion takes place.  The bond tech gears do not appear to move...at least the passive one.

When I go to print anything, or do a first layer calibration, there's no extrusion at all...not even the primer strip.

I'm at a loss.  Any guidance would be appreciated.  Thanks.

Posted : 25/07/2020 7:45 pm
Share:

Please Login or Register