Broken extruder wire  

  RSS
lembo
(@lembo)
Active Member

I left the room and came back to find my print had not stuck to the surface (textured surface). All of the filament had stuck to the hotend. When pulling it off, I accidently pulled loose a wire. It may be the hotend thermistor wire. How can I fix this? Here is a photo link.

Posted : 21/12/2019 8:45 am
JoanTabb
(@joantabb)
Moderator

Put some sleeving on the wire, re solder the ends together, insulate with sleeving. 

if the sleeving is heatshrink sleeving, shrink to size!

regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK...
Posted : 21/12/2019 9:55 am
Share:

Please Login or Register