Benchy failing at Arch  

  RSS
Finn
 Finn
(@finn-2)
Active Member

Hello there.

After getting some new filament I did a Benchy for each of them (PETG and PLA). Both Prusament.

Every Benchy came out greate. But not the last 2 PLA Benchys.

Always fail at the exact same moment. While printing the overhang from the door. Seams like the nozzle gets stuck on filament that is higher then it is supposed to be. The nozzle looks clean to me and the part looks great bevor the fail.

Any suggestions?

Posted : 08/02/2021 4:13 pm
Share:

Please Login or Register