Notifications
Clear all

Bed Thermistor cablr damage  

  RSS
Adamtj3
(@adamtj3)
New Member
Bed Thermistor cablr damage

Hi

I was midway through a 42hr print when a MINTEMP error appeared on my Prusa i3 MK3s.

What I found was the above damage to the thermistor cord and was wondering if anyone has had similar damage?

As it appears to be heat damage and would like to fix anything else that might of caused this before the replacement bed thermistor I ordered arrives.

Any help is greatly appreciated.

Posted : 29/12/2020 11:26 pm
Swiss_Cheese
(@swiss_cheese)
Noble Member
RE: Bed Thermistor cablr damage

Looks like a pinch to me. that wire and the bed wires should be warped in a sleeve keeping them from getting pinched.

The Filament Whisperer...
Posted : 29/12/2020 11:52 pm
Adamtj3 liked
Adamtj3
(@adamtj3)
New Member
Topic starter answered:
RE: Bed Thermistor cable damage

I have removed the sleeve to find the damage.

When the replacement is put in, I will make sure it cannot be caught anywhere with the sleeve on.

 

Thank you for the feedback

Posted : 30/12/2020 12:08 am
Share: