Notifications
Clear all
Bed is level, but it isn't. Huh?
I have an MK3 heated bed and I've been using it for approx 2 years. I recently need to use the entire bed to print and my leveling issues are showing up on my prints. I'm on the latest firmware/software, am using PRUSA Slicer and OctoPrint.
I've reset calibrations from scratch, installed adjustable levelers in the bed using the center point as level, used three different Octoprint leveling plug-ins, all now say I'm almost perfectly level using 3x3 and 7x7 mesh.
Yet, when I print the right side is definitely too far from the nozzle and the left is definitely too close.
If I make adjustments, bed leveling fails.
If I try bed leveling correction in the controls, it seems like it isn't making any difference.
Any clue what would cause this?
TIA!
Posted : 06/01/2020 5:53 pm