Bad Y Axis Shift. Can you help me identify the problem?!
 
Notifications
Clear all

Bad Y Axis Shift. Can you help me identify the problem?!  

  RSS
Myers Woodshop
(@myers-woodshop)
Member
Bad Y Axis Shift. Can you help me identify the problem?!

Bad Layer shifting in i3 mk3s. right is first print, left is second AFTER belt tightening. 

Running latest firmware, 3.7.2. hatbox pla. .20 with 25% infill. using prusa slicer 2. belts feel tight and are within acceptable range according to settings numbers. after i tightened belt i reran xyz calibration, heat calibration, cleaned bed with acetone. Can't figure it out.

Y axis layer shift. Any help is very welcome at this point as my 1/4 priced ender 3 is printing better at this point...

www.youtube.com/myerswoodshop

Posted : 05/08/2019 10:00 pm
Dave Avery
(@dave-avery)
Honorable Member
RE: Bad Y Axis Shift. Can you help me identify the problem?!

is crash detection on and did any crashes register?

Posted : 05/08/2019 10:04 pm
Myers Woodshop
(@myers-woodshop)
Member
Topic starter answered:
RE: Bad Y Axis Shift. Can you help me identify the problem?!

crash detection is on.  not sure if any registered.  will it show me the last print stats somewhere?

 

 

www.youtube.com/myerswoodshop

Posted : 05/08/2019 10:07 pm
Dave Avery
(@dave-avery)
Honorable Member
RE: Bad Y Axis Shift. Can you help me identify the problem?!

try with crash detection off - there is a known issue with over sensitivity to Y crashes

Posted : 05/08/2019 10:11 pm
karl-herbert
(@karl-herbert)
Illustrious Member
RE: Bad Y Axis Shift. Can you help me identify the problem?!

depending on precision of printer's (ziptie) assembly, crash detection could be a problem, thats why i never used crash detection "on" since i'm printing miles of different filaments without any problems.

Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.

Posted : 06/08/2019 10:59 pm
Share: