Any easy way to turn off nag message before I upgrade firmware?
This afternoon I clicked on the 'load updated parameters' (or something similar) message when I ran PrusaSlicer and now whenever I go to do a print it displays this 'Updated firmware available, please upgrade' message at the start of each print and does appear to delay the print start.
I don't want to flash new firmware until I finish with some important prints.
Is there any convenient way of turning off this nag message, at least temporarily?
Thanks.
RE: Any easy way to turn off nag message before I upgrade firmware?
Look in the Start Gcode tab under Printer Settings.
Comment the first line, or the one that has a comment about current firmware. Boom! No nag message.
RE: Any easy way to turn off nag message before I upgrade firmware?
Thanks.
I assume it's this line:
M115 U3.9.0 ; tell printer latest fw version
I won't be able to try it for a while because the current print has 6 more hours to run, but we'll see if it works after that.
RE: Any easy way to turn off nag message before I upgrade firmware?
Or deactivate Firmware checks in the hardware settings of your printer.
RE: Any easy way to turn off nag message before I upgrade firmware?
Or deactivate Firmware checks in the hardware settings of your printer.
I tried to do this, and for whatever reason the change didn't seem to make any difference. I had to comment out the line in my start gcode as described above. Printer in question has a modified (100mm taller) Z axis, which required compiling custom firmware. Which I am not going to repeat every time Prusa comes out with an update unless there is some compelling reason to do so.
RE: Any easy way to turn off nag message before I upgrade firmware?
Same situation for me, turning off in firmware didn't turn off the messages, quite frustrating.